How To Set Water Softener Meter

Thursday, July 27, 2017

How To Set Water Softener Meter

If you lose power your softener will flush sooner than it is supposed too. Menu 4 is regeneration time.

Aquasure Harmony Series 48 000 Grain Digital Metered Water

Fleck 5600 Sxt Metered Water Softener 5600sxt

Operating Instructions Setting The Time Of Day Time Of

These should measure hardness or alkalinity in parts per million ppm.

How to set water softener meter.

The regeneration time menu is in 24 hour format and has hour and minute values.
Because a water conditioner or water.
This is any.

The frequency of water conditioner regeneration cycle or.
We recommend to set it at 2 am or 3 am when nobody is using the water.
Set the salt dose.

If you have an older water softener you will need to pull the dial slightly out before turning the hour and minutes dials to set the current time.
To set the softener up correctly it is also necessary to know the hardness of the water.
This is an instructional video that explains how to adjust the settings for the fleck 5600 econominder water softener.

Press the buttons marked hour and minutes on your water softener to set the current time.
Test strips are the easiest and quickest to use.
The first thing you will need is a test method for water hardness.

With the capacity and the hardness level known add 3 grains hardness for each ppm of iron present in the water.
3 pull out the timer knob and set the current time on the.
Hardness is a measure of the calcium and magnesium present in the water.

Check with your water softener system supplier or your local hardware store for these.
Follow the steps in menu 3 to set the regeneration time.
The amount of salt or salty water that must be run through.

Four basic adjustments or tasks necessary to use a water softener set the regen or backwash frequency.
Ever wonder what the different dials or gears on your water softener are for.
This video shows how to set the timer on your water softener to flush at night when you are not using water.

Softeners should be sized and set to work at 75 capacity which requires half as much salt.
Set your water softeners hardness dial sometimes referred to as a brine control to match the gpg figure determined by the water test.
It is the time when the water softener regenerates the supply of soft water.

It is expressed either in parts per million or more commonly in grains per gallon.