This list below shows some models of netgear access point and their default ip address. The basic page displays.
Connect the router that you just set up as an access point to one of the available ethernet router in the network the main router.
How to setup netgear router as access point.
Click a device to see the user manual and installation guide.
Connect a computer to the netgear ap router and launch a web browser.
The other existing router on the network assigns an ip address to this router while this router is in ap mode.
The second router now is set up and connected to function as an access point.
Thus you can easily access these options.
Instead of getting rid of that old and busted wi fi router you can use it instead to extend the wi fi coverage of your home.
You will have to change the ip address.
Once netgear genie detects that there is an existing network it gives you the option to set your nighthawk router to access point ap mode or to router mode.
Cant log into router configured as access point open the command prompt using the run dialog box.
The default ip address of your ap will be on a sticker on the rear or bottom of the ap.
I just bought a new router r6250 which i would put up as an access point so i could get a better signal upstairs and not switch between router and extender.
Next you should give the ipconfig command on the command prompt and push the enter button.
Use an ethernet cable to connect the ap router internet port to a lan port on the existing main router.
This person is a verified professional.
How to turn an old wi fi router into an access point.
Access the ap router web interface using a computer that is connected to one of the lan ports of the netgear router.
Verify your account to enable it peers to see.
To configure your netgear router as an ap.
Among all the information displayed there is the default ip.
You are prompted to enter a username and password.
Connect your nighthawk router to your network.
Select enable ap mode.
Click advanced advanced.
Select advanced advanced setup wireless ap.
To set your netgear modem in ap mode.
Scroll down to choose ip address settings on this access point and select get dynamically from existing router.
Power on your nighthawk router and wait for the lights to become stable.
For more information see restoring a netgear home router to the factory default settings.
Before i had an extender but it was annoying to switch between the diffrents networks as i was up or downstairs.
To install the nighthawk router in ap mode.
No comments:
Post a Comment